Setup; Autotest - JDS Uniphase Certifier40G Manual

1.13.4
Pressing the SETUP button, or starting up the Certifier40G,
brings you to this section. This section has 3 navigation tabs
at the bottom, each allowing you to configure different
settings. The test settings tab lets you setup the AutoTest
configuration including the limits, cable type, labels for
saving results etc. The system settings tab allows you to set
the system settings like Date/Time, Auto sleep, Auto saving
of results in the memory etc. The last navigation tab in the
setup section is information, which provides information such
as calibration status, adapter (probe) status and type of
adapter etc.
Figure 3: Test Settings
1.13.5
The one touch AUTOTEST button allows you to start the test
with just one click if both the local and remote units are
correctly connected. You can view the summary results
screen once the auto test is completed. The result of the test

Setup

Figure 4: System

Autotest

Settings
17
Getting Started
Figure 5: Information