Table of Contents
Advertisement
4.14 AFTER USE
After use all machining residues or other humid or dusty
materials must be cleaned from the machine. Keep the
machine clean and in good condition. It will continue to
give better results.
WARNING!
After use always make sure that the electric power
supply has been disconnected.
4.15 SHUTDOWN
If the machine is to be shut sown for a prolonged
period of time the parts subject to wear must be
lubricated and the machine covered with a plastic
sheet and stored in a sheltered, dry place. If these
instructions are observed when work with the saw is
resumed the machine will be in perfect working order.
SECTION 5
5.1 MAINTENANCE
It is essential for all maintenance operations to be
performed with the motor off and the machine
unplugged from the power supply.
Apart from the oil change in gear-motor, the machine does
not require any particular maintenance operations. It is
however important to remember the following:
· Clean the machine and the work area regularly.
· Use saw blades with teeth that are suitable for the
materials to be cut; this ensures optimum cutting
results. Your saw blade supplier can provide you with
helpful advice.
· Replace the saw blade when it is worn, in order to avoid
vibrations and inaccurate cuts.
· Clean the coolant tank when necessary, or at least,
twice a year, through the special opening on the tank
itself.
· Check the cooling pump regularly.
· Ensure that the safety guard completely covers the
blade.
FOR
ANY
DESCRIBED
MANUFACTURER IMMEDIATELY.
5.2 ELECTRICAL SYSTEM
The saw is equipped with a 24 Volt low voltage electrical
system.
16
MAINTENANCE
WARNING!
WARNING!
PROBLEMS
OTHER
ABOVE
CONTACT
THAN
THOSE
THE
Advertisement
Table of Contents
