Handling - Garrick BS260 Instruction Manual

SECTION 3
HANDLING AND INSTALLATION

3.1 HANDLING

For long distance the machine may be transported on
lorries or train wagons.
See "1.7 Technical Characteristics" for the weight and size
of the machine.
The saw is usually supplied packaged in plastic or
strapped, and palletized. If so, the machine can be easily
moved, loaded or unloaded with a normal lift truck of
suitable lifting capacity (Fig. 5).
If , on the other hand, the machine is shipped without
being palletized then it must be lifted using a crane and
ropes or chains with a suitable capacity and marked as
such. The ropes or chains must be attached to bade of
vise. (Fig. 4)
WARNING!
Before starting to lift the machine make sure that all
movable parts have been securely fastened.
Ensure that the crane's lifting capacity is suitable for the
machine. Lift the machine carefully and move it slowly,
avoiding bumps or sudden movements.
Fig.4-Lift ropes for lifting the machine
The lifting and transporting operations can be extremely
dangerous if not carried out with maximum caution. Move
all unqualified personnel away from the area. Clean, clear
and close off the installation area. Check the condition
and suitability of the equipment available. Do not touch
the suspended loads and remain at a safe distance from
them. During transportation, the loads must not be lifted
more than 20 centimeters from the ground. Finally,
prepare an adequate space as an escape route in the
event that the load should fall.
The surface onto which the machine is to be placed
must be perfectly level in order to prevent any
possible shifting of the load.
Once the machine has been lifted onto the lorry or train
wagon male sure that it is locked into position, by securing
it firmly to the base by means of ropes or chains.
When it has reached its destination, before releasing the
machine from its constraints check that the condition and
position of the machine are not hazardous. Then remove
the ropes or chains and unload the machine using the
same means and methods used to load it.
9
DANGER!
WARNING!
Fig.5