Epson TM-C3500 Series Developer's Manual page 57

• Paper with holes or cutouts cannot be used.
• Auto cutting on the perforated lines will generate scraps of paper that may
• Set the black mark position 2 mm or more from the perforated line.
• For the black mark position of the die-cut label paper, match the label
• Use uncut perforations on both sides of the paper.
• Both types, paper without waste part and paper without the left and right
• Providing a black mark on both sides enables the paper to be used even
c
IMPORTANT
Paper width center
Black mark
position
when
inserted in
reverse
direction
Perforation
position
2 mm or
more
Fanfold
paper
Depending on the shape of die-cut labels, the labels may peel off their
Q
backing paper inside the printer. When you want to use die-cut labels that do
Note
not meet the specifications, contact qualified service personnel for advice.
cause problems. Also, auto cutting ahead of the perforated line may cause
problems when feeding paper. Therefore, perform auto cutting 0.5 to
1 mm behind the perforated line.
leading edge to the black mark leading edge.
waste parts, can be used.
when inserted from either side.
<Back side>
Mark center position
Mark width
<Print side>
Paper width
center
Normal black
mark position
Backing paper
Label
Paper feed
direction
57