Related Manuals for Scheppach BASATO 4
Summary of Contents for Scheppach BASATO 4
- Page 1 Safety notes Safety notes 15/11/07 (W856) Safety notes INSTRUCTION MANUAL Safety notes BASATO 4 Safety notes RBS380 Safety notes Please read the manual carefully before operate this machine!
- Page 2 Fig. 1 Fig. 5.1 Fig. 2 Fig. 5.2 Fig. 3 Fig. 5.3 Fig. 4 Fig. 6...
- Page 3 Fig. 1/UG Fig. 2/UG Fig. 3/UG Fig. 3.1/UG Arbeitsstellung Fahrstellung...
-
Page 4: Fig
Fig. 7 Fig. 11 blue micro switch blue brown black blue main brown white auxidiary black blue protector yellow and green KJD18 / 230 V switch - 1Phase Fig. 8 Fig. 12 micro switch ➁ KJD18 / 230 V switch - 3Phase ➂... - Page 5 • Observe all safety instructions and warnings attached to the machine by carefully reading these instructions. the machine. • Use only original scheppach accessories, wearing or re- • See to it that all safty instructions and warnings attached placement parts. You can find replacement parts at your to the machine are complete and perfectly legible.
- Page 6 • Insure sufficient lighting in the work area and the area • Wear a cap or hair net to protect long hair. around the machine. • Do not wear work gloves while you use the saw, except • Caution when working: There is a danger to fingers and from rough materials.
-
Page 7: Fig
• Caution: Always place the upper saw blade guidance in • Relevant accident prevention regulations and other, gen- the lowest position and lock it before you transport the erally recognized safety-technical rules must also be ad- machine. The door must always be closed and locked. hered to. -
Page 8: Fig. 4
must be placed in the lowest position and close to the • Turn the four wing-bolts, each with a flat washer, roughly 5 mm into the table surface (Fig. 5.1) table. • Place the guidance tube so that it touches the table and lightly tighten the wing-bolts. - Page 9 • Loosen the saw blade by unscrewing tightening screw tion (e.g. after finishing work). Attach a notice on the tension of the saw band to the machine for the next • Fit the new saw blade. user. • Turn the band wheel by hand in the cutting direction, •...
- Page 10 • Extension cords up to 25 metres in length must have a cross section of 1.5 square millimetres; those over 25 We, Scheppach Fabrikation von Holzbearbeitungsmaschinen GmbH, metres must have a cross section of at least 2.5 square Günzburger Str. 69, D-89335 Ichenhausen hereby declare that the ma- chine named below correspondends to the relevant safety and health millimetres.
- Page 11 Trouble shooting Fault Possible cause Solution Motor does not start a) No power a) Check mains connection b) Switch, Condenser b) Have them checked by an electrical c) Electrical extension cord is defective engineer c) Remove the plug from the socket, check it, and replace if necessary Saw blade is not a) Guide has been wrongly set...
- Page 14 106 international...
- Page 15 General Machinery Safety Instructions Machinery House requires you to read this entire Manual before using this machine. 1. Read the entire Manual before starting 14. Use correct amperage extension cords. machinery. Machinery may cause serious injury if Undersized extension cords overheat and lose not correctly used.
- Page 16 Wood Bandsaw Safety Instructions Machinery House requires you to read this entire Manual before using this machine. 1. Maintenance. 11. Work area hazards. Make sure the bandsaw is turned Keep the area around the off and disconnect from the main power supply bandsaw clean from oil, tools, chips.