Start-Up Checklist - Carrier Omnizone 09XC06 Installation, Start-Up And Service Instructions Manual

Remote air-cooled condenser units

Hide thumbs

Table of Contents

NOTE: To avoid injury to personnel and damage to equipment or

property when completing the procedures listed in this start-up

checklist, use good judgment, follow safe practices, and adhere

to the safety considerations/information as outlined in preceding

sections of this Installation, Start-Up, and Service document.

I. PRELIMINARY INFORMATION

MODEL NO. ____________________

09XC UNIT:

FIELD-INSTALLED ACCESSORIES: _____________________________________________________________________

START-UP DATE: ______________________________________

II. PRE-START-UP:

VERIFY ALL SHIPPING MATERIALS HAVE BEEN REMOVED FROM THE UNIT

IS THERE ANY SHIPPING DAMAGE? ________________ IF SO, WHERE ________________

_____________________________________________________________________________________________________

WILL THIS DAMAGE PREVENT UNIT START-UP?

CHECK POWER SUPPLY. DOES IT AGREE WITH UNIT?

HAS THE GROUND WIRE BEEN CONNECTED?

HAS THE CIRCUIT PROTECTION BEEN SIZED AND INSTALLED PROPERLY?

ARE THE POWER WIRES TO THE UNIT SIZED AND INSTALLED PROPERLY?

HAVE CONDENSER FAN AND MOTOR PULLEYS BEEN CHECKED FOR PROPER

ALIGNMENT AND DO THE FAN BELTS HAVE PROPER TENSION?

HAS CORRECT FAN ROTATION ON CONDENSER BEEN CONFIRMED?

ARE PROPER AIR FILTERS IN PLACE AND ARE FILTERS CLEAN?

VERIFY UNIT IS INSTALLED WITHIN LEVELING TOLERANCES

CONTROLS

HAVE CONTROL CONNECTIONS BEEN MADE AND CHECKED?

ARE ALL WIRING TERMINALS (including main power supply) TIGHT?

PIPING

HAVE LEAK CHECKS BEEN MADE AT COMPRESSOR, CONDENSER, EVAPORATOR, TXVs

(Thermostatic Expansion Valves), SOLENOID VALVES, FILTER DRIERS, AND FUSIBLE PLUGS

WITH A LEAK DETECTOR? (Y/N) _______

LOCATE, REPAIR, AND REPORT ANY LEAKS

HAVE ALL COMPRESSOR SERVICE VALVES BEEN FULLY OPENED (BACKSEATED)? (Y/N) _______

HAVE LIQUID LINE SERVICE VALVES BEEN OPENED? (Y/N) _______

IS THE OIL LEVEL IN THE COMPRESSOR CRANKCASE ON THE UNIT IN VIEW IN THE

COMPRESSOR SIGHT GLASS (IF APPROPRIATE)? (Y/N) _______

HAS CONDENSER PRESSURE RELIEF BEEN PROVIDED? (Y/N) _______

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Catalog No. 04-53090029-01