Carrier Omnizone 09XC06 Installation, Start-Up And Service Instructions Manual page 17

LEGEND
C — Compressor Contactor
DISC — Disconnect
GND — Ground
OFM —
Outdoor-Fan Motor
OFR —
Outdoor-Fan Relay
PRES — Pressure Transducer
TB — Terminal Block
VFD — Variable Frequency Drive
Fig. 11 — Typical Wiring Schematic for Low Ambient Option (09XC06,08 Units)
NOTES:
Terminal Block Connection
Marked Terminal
Unmarked Terminal
Splice
Factory Wiring
Field Power Wiring
17
1. Fan motors are inherently thermally protected.
2. Three-phase motors are protected under primary
single phase conditions.
3. Use conductors suitable for at least 194°F (90°C)
when replacing factory wiring.
4. Use copper conductors only.
5. Wiring for field power supply must be rated at 165°F
(75°C) minimum.