Table of Contents
Advertisement
T. Thermostat Battery Replacement
This thermostat is powered by two "AA" Alkaline batteries.
The batteries should be replaced AT LEAST once per
year to ensure reliable operation or sooner if the LO BATT
appears on the display screen. The batteries are located
on the back of the thermostat's circuit board. The front
portion of the thermostat can be removed from the back
half by using the tabs on the top edge of the thermostat
housing (Figure 16.1).
Figure 16.1
When installing new batteries, it is recommended using only
brand new "AA" size alkaline batteries. Please verify the
polarity markings shown in the battery compartment before
adding batteries to the compartment. When finished, line
up the front of the thermostat to the base, and firmly press
together to securely latch the front and back halves together
properly.
BATTERY GRAPHIC:
Anytime time the batteries are physically present in the
thermostat, there will be a visual indicator showing the life of
the battery. This will appear on the display screen (Figures
16.2 and Figure 16.3).
Figure 16.2 - Full battery icon
Figure 16.3 - Low battery icon
16
CONNECT THERMOSTAT WIRES TO APPLIANCE:
There is a 4 screw terminal block located on the back
lower left corner of the stove directly above the power
cord inlet. The center 2 screws are for the thermostat
wires (Figure 16.4).
Figure 16.4
Shock hazard.
• Do
from plug.
• Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front
of appliance.
7027-805H
Terminal Block
Center 2 Screws for
Thermostat Wires
Power Outlet
CAUTION
NOT
remove
grounding
prong
01/21
Advertisement
Table of Contents
