Meyer Sound LYON-M Operating Instructions Manual page 42

Linear line array loudspeaker
Table of Contents

Advertisement

LYON OPERATING INSTRUCTIONS
LYON Specifications
Input Level
AMPLIFIER
Type
Total Output Power
THD, IM, TIM
Cooling
AC POWER
Connector
Voltage Selection
Safety Agency Rated Voltage
Range
Turn-on/off Points
CURRENT DRAW
Idle
Maximum Long-Term Continuous
(> 10 sec)
Burst (< 1 sec)
Maximum Instantaneous Peak
Inrush
RMS NETWORK
PHYSICAL
Enclosure
Finish
Protective Grille
Rigging
Dimensions
Weight
ENVIRONMENTAL
Operating Temperature
Non Operating Temperature
Humidity
Operating Altitude
Non Operating Altitude
Shock
Vibration
42
Audio source must be capable of producing +20 dBV (10 V rms) into 600 Ω to produce
the maximum peak SPL over the operating bandwidth of the loudspeaker
3-channel, complementary MOSFET output stages (class AB/H bridged)
8500 W peak
Note: Peak power based on the maximum unclipped voltage the amplifier will produce
into the nominal load impedance.
< 0.02%
Two ultra high-speed primary fans, two ultra high-speed reserve fans
powerCON 32 input
Automatic, two ranges, each with high-low voltage tap (uninterrupted)
95–125 V AC; 208–235 V AC, 50–60 Hz
Turn-on: 85 V AC; Turn-off: 134 V AC
Turn-on: 165 V AC; Turn-off: 264 V AC
1.2 A rms (115 V AC); 0.6 A rms (230 V AC); 0.7 A rms (208 V AC)
11.2 A rms (115 V AC); 5.6 A rms (230 V AC); 6.2 A rms (208 V AC)
15.4 A rms (115 V AC); 7.5 A rms (230 V AC); 8.2 A rms (208 V AC)
Note: AC power cabling must be of sufficient gauge so that under burst rms current con-
ditions, cable transmission losses do not cause the loudspeaker's voltage to drop below
the specified operating range.
45 A peak (115 V AC); 23 A peak (230 V AC); 25 A peak (208 V AC)
<15 A peak
Equipped with two-conductor twisted-pair network; reports all operating parameters of
amplifiers to host computer.
Premium multi-ply birch
Slightly textured black
Powder-coated, hex-stamped steel with acoustical black mesh
End frames with captive GuideALinks secured with 0.4375 in x 0.090 in quick-release
pins that allow 0.5° to 9.0° splay angles (8° to 15° splay angles supported with
LYON-WXT); detachable side handles
W: 38.15 inches (969 mm) x H: 14.85 inches (377 mm) x D: 21.00 inches (533 mm)
199 lb (90.3 kg)
0 °C to +45 °C
–40 °C to +75 °C
To 95% at 45 °C (non-condensing)
To 5,000 m (16,404 ft)
To 12,000 m (39,000 ft)
30 g 11 msec half-sine on each of 6 sides
10 Hz – 55 Hz (0.010 m peak-to-peak excursion)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lyon-wLyon-wxt

Table of Contents