American Dynamics LT Installation And Operation Instructions Manual page 52

MegaPower LT
Configuring the AD2088 keyboard baud rate:
1. Turn the key to MENU
2. Press the "F1" button
3. The word BAUD should be displayed on the keyboard LED screen
4. Use the "NEXT" or "LAST" button to change to the desired baud rate (1200, 2400,
4800, 9600, 19200, or 38400)
5. When done, turn the key back to "OPERATE"
CHANGING REPEAT MODE TO OFF ON THE AD2088 KEYBOARD:
1. Turn the key to "MENU", and then press the "F1" button
2. The worf "BAUD" should be displayed. Press the "PROG" button BUTTON UNTIL
YOU SEE "AUTO RPT = AUTO or ON".
3. USE THE "NEXT" OR "LAST" BUTTON TO CHANGE IT TO "OFF"
4. TURN THE KEY BACK TO "OPERATE"
Configuring the ADTTE Touch Tracker baud rate:
1. Press the "+" button to enter programming mode
2. Enter 1200 and press F1 for 1200 baud (baud rate can be 1200, 2400, or 9600)
3. Press the "-" button to exit programming mode
CHANGING REPEAT MODE TO OFF ON THE ADTTE TOUCH TRACKER:
1. Press the "+" button to enter programming mode
2. Enter 200, F1
3. Press the "-" button to exit programming mode
Configuring theADCC200/300 keyboard baud rate:
1. Setting the protocol:
a. Access SPECIAL CONFIG MENU by pressing SHIFT
of applying power to the keyboard.
b. Press the VCR RECORD
c: Press number 1 FOR RS-485 OR 2 for RS-232 and then press the ENTER button
2. Setting the ADCC200/300 baud rate:
a. Access SPECIAL CONFIG MENU by pressing SHIFT
of applying power to the keyboard.
b. Press the VCR REWIND
c: Press number 1 FOR RS-485 OR 2 for RS-232 and then press the ENTER button
button
button
44
and within 5 seconds
and within 5 seconds