Advertisement
Table of Contents
These kits are sets of RJ45 tips, latches, and cases that replace
worn parts on these DSX and DTX permanent link adapters:
DSX-PLA-004-RKIT
DSX-PLA-804-RKIT
DTX-PLA002PRP
PN 4969875 January 2018
©2018 Fluke Corporation
All product names are trademarks of their respective companies.
DSX-PLA-004-RKIT
DSX-PLA-804-RKIT
DTX-PLA002PRP
Replacement Parts for DSX and DTX
Installation Guide
Kit
Permanent Link Adapters
Adapter
DSX-PLA004
DSX-PLA804
DTX-PLA002
Advertisement
Table of Contents
Related Manuals for Fluke DSX-PLA-004-RKIT
Summary of Contents for Fluke DSX-PLA-004-RKIT
- Page 1 These kits are sets of RJ45 tips, latches, and cases that replace worn parts on these DSX and DTX permanent link adapters: Adapter DSX-PLA-004-RKIT DSX-PLA004 DSX-PLA-804-RKIT DSX-PLA804 DTX-PLA002PRP DTX-PLA002 PN 4969875 January 2018 ©2018 Fluke Corporation All product names are trademarks of their respective companies.
- Page 2 The kits include these items: Two RJ45 tips Two top and bottom cases (DSX kits only) Two latches Two conductive pads Two screws (DSX-PLA-804-RKIT only) Two conductive washers Installation instructions Symbols Warning or Caution: Risk of damage or destruction to equipment or software.
- Page 3 How to Replace the Tip and Latch Remove the adapter from the tester. Use a Phillips screwdriver to loosen the screw on the connector case; then remove and replace the tip or latch as shown below. Make sure that the conductive washer is on the case screw as shown below.
- Page 4 Life of tip contacts (typical): > 5,000 cycles For more performance specifications on the DSX or DTX adapters, see the Versiv Series Technical Reference Handbook or the DTX Technical Reference Handbook or visit the Fluke Networks website. Contact Fluke Networks ...
Need help?
Do you have a question about the DSX-PLA-004-RKIT and is the answer not in the manual?
Questions and answers