Table of Contents
Advertisement
1.
When working with the nozzle, please wear appropriate clothing (boots,
safety glasses, robust clothing). Observe the safety notes in this manual!
2.
Attach the nozzle to the tilting arm and set the working angle as desired.
Always mount both extensions between the tilting arm and the regulator!
3.
Set the desired water jet type by turning the nozzle. Always make sure the
nozzle firmly locks in position! Always turn off the water supply before ma-
nipulating the nozzle.
4.
Proceed as mentioned under point 3 and 4 in the chapter "Using the Nozzle".
Jet Types
You have the choice of five types of jets:
a narrow, sharp cleaning jet,
a broader, sharp cleaning jet,
a simple cleaning jet,
a broad cleaning jet tilted down,
a broad, soft jet for rinsing.
Hints
1. Do not use detergents which are too liquid, no powders and no solids.
2. Whenever possible, use a viscous liquid detergent.
Cleaning and Maintenance
Do not leave the unit in the sun for extended amounts of time.
After use, remove all remaining detergent from the container and carefully
rinse it with fresh water. Fill the container with water and flush the unit out.
Residual detergent will be flushed out and cannot dry and clog the unit.
After use, take the unit down and flush all components with water. Carefully
clean the nozzles and the brush with fresh water.
Always store the brush with the bristles up so no dirt will get caught in them.
Technical Data
Please Notice: The pressure and range of the water jets directly depends on the
pressure of the water supply to which the unit is connected. Therefore, operate
the unit from a water supply with sufficient pressure.
Assembled Length
Brush Diameter
Weight
Safety Notes and Using
142 cm
18 cm
1 kg
8
Advertisement
Table of Contents
