Table of Contents
Advertisement
the desired detergent. Before attaching the container, make sure the O-ring
is seated correctly at the mounting flange of the container. Reattach the
container; please do not over tighten it.
4.
Before detaching the container, make sure the regulator is set to OFF. After
operation the container may be a little tight in the treads.
5.
Tilt the brush head as desired. To do so, loosen the wing nut and slightly pull
the halves of the joint apart. Tilt the brush head to the desired angle and
retighten the wing nut.
Preparation for Use
Attention! Do not use hot water! The Temperature must be under 60° C!
1. Before starting work, make sure the selector is set to OFF.
2. Rinse the surface to be cleaned with fresh water before applying detergent.
This will soften the dirt; do not apply brush and detergent to a dry surface.
3. Never clean painted surfaces heated by direct sunlight.
4. Please be very careful not to touch the painted surface with the detergent
container or other plastic parts. This may damage the surface.
Using the Brush
1.
Attach the brush head to the tilting arm and set
the angle as desired. Always mount both exten-
sions between tilting arm and regulator!
2.
Set the regulator either to SOAP, to add
detergent to the water, or to RINSE, to use fresh
water. The position of the regulator determines
how much detergent is added.
3.
After some time, when the detergent has been consumed, the container is
filled with clear water. Turn off the water supply (regulator to f OFF) and refill
the container with detergent.
4.
When using the brush, apply only light pressure. Use the circular movement
of the brush to move it over the surface. Avoid forcing the brush against the
surface.
Using the Nozzle
The water jet from the nozzle is tightly focused and
may have a range of up to 20 meters, use the nozzle
with care!
Safety Notes and Using
7
Advertisement
Table of Contents
