Advertisement
Toggling between the Primary
and Secondary Unit
1. Press Menu.
2. Using the Tracker Ball, scroll
down to Tog Primary/2nd.
3. Press the left zoom/focus button
(line 1) or right zoom/focus
button (line 2) to select the Tog
Primary/2nd menu option.
4. Press Next to toggle between using
the primary (Main) unit for
SensorNet polling and alarm
monitoring or as the secondary
(Call) unit with limited user
functionality.
5. Press Menu to reset the controller
as a primary or secondary unit.
The controller will reboot and return
to the Camera Control Mode.
Toggling between Zoom and
Focus
1. Press Menu.
2. Using the Tracker Ball, scroll
down to Tog Zoom/Focus.
8000-0982-02, Rev. C
AD T
Installation Instructions
3. Press the left zoom/focus button
(line 1) or right zoom/focus
button (line 2) to select the Tog
Zoom/Focus menu option.
4. Press Next to switch the Zoom and
Focus functions between the right
and left buttons.
5. Press Menu to exit.
Adjusting V-Phase
1. Press Menu.
2. Using the Tracker Ball, scroll
down to Adjust V-Phase.
3. Press the left zoom/focus button
(line 1) or right zoom/focus
button (line 2) to select the
Adjust V-Phase menu option.
4. Press Next or Previous to observe
V-Phase through the oscilloscope
or Fluke scope.
5. Press Menu to exit.
Off-line domes or fixed cameras will
generate a warning beep and disallow use
of the V-Phase utility. For additional
information on adjusting V-Phase, see the
Service section of the AD T
manual.
T
16
OUCH
RACKER
T
16
OUCH
RACKER
Installation Instructions
5
Advertisement
