Makita HM1111C Instruction Manual
Hide thumbs
Also See for HM1111C:
- Instruction manual (45 pages) ,
- Instruction manual (37 pages) ,
- Instruction manual (41 pages)
Related Manuals for Makita HM1111C
Summary of Contents for Makita HM1111C
- Page 1 INSTRUCTION MANUAL Demolition Hammer HM1111C HM1101C DOUBLE INSULATION Read before use.
-
Page 2: Specifications
Waste Electric and Electronic Equipment mined according to EN60745: and its implementation in accordance with Model HM1111C national law, electric equipment that have Work mode : chiselling function with side handle reached the end of their life must be col- Vibration emission (a ) : 7.5 m/s... -
Page 3: Ec Declaration Of Conformity
12. Use personal protective equipment. Always wear eye EC Declaration of Conformity protection. Protective equipment such as dust mask, non- skid safety shoes, hard hat, or hearing protection used for For European countries only appropriate conditions will reduce personal injuries. The EC declaration of conformity is included as Annex A 13. -
Page 4: Functional Description
HAMMER SAFETY WARNINGS FUNCTIONAL DESCRIPTION Wear ear protectors. Exposure to noise can cause hearing loss. Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury. CAUTION: Hold power tool by insulated gripping sur- • Always be sure that the tool is switched off and faces, when performing an operation where unplugged before adjusting or checking function the cutting accessory may contact hidden wir-... -
Page 5: Indicator Lamp
5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. For tool with D-shaped side handle For Model HM1111C only NOTE: • Blows at no load per minute becomes smaller than those on load in order to reduce vibration under no load, but this does not show trouble. - Page 6 Installing or removing the bit ► 1. Releasing cover To remove the bit, pull the releasing cover down all the ► 1. Bit shank 2. Bit grease way and pull the bit out. Bit angle Clean the bit shank and apply bit grease before install- ing the bit.
-
Page 7: Operation
Authorized Service Centers only. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. It should be relubricated regularly. Send the complete tool to Makita Authorized or Factory Service Center for this lubrication service. To maintain product SAFETY and RELIABILITY, repairs,... - Page 8 Makita Europe N.V. Jan-Baptist Vinkstraat 2, 3070 Kortenberg, Belgium Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 884957C227 www.makita.com 20190116...