Maintenance - Makita AN610H Instruction Manual

For No. (1) method, set the change lever to
•
the position.
For No. (2) method, set the change lever to
the position.
After using the change lever to change the nailing
method, always make sure that the change lever
is properly set to the position for the desired
nailing method.
Fig.12
Fig.13
Nailing of steel plate
WARNING:
Use 2.3 mm or les steel for C-shaped one.
•
The tool will bounce severely and a nail struck
back, causing serious injuries.
Use hardened nails only for steel plate.
•
Using other purposed nails may cause serious
injuries.
When nailing, hold the tool so that it stands upright
•
to the driving surface.
Slanted nailing may cause nails to strike back,
causing serious injuries.
When fastening a corrugated zinc plate on the C-
•
shaped steel, use 0.7 mm or less thick plate and
32 mm long hardened nails. Failure to do so may
cause nails to strike back, causing serious injuries.
Do not use the tool for nailing on ceiling or roof.
•
Choose and use nails more than 10 mm longer than
total thickness of all workpiece to be fastened by
referring to the table below.
Material thicknes
(mm)
1.8-22
10-27
15-30
15-38
009186
Fig.14
Fig.15
CAUTION:
Depending on the hardness and total thickness of
•
all workpiece in combination to be fastened,
enough fastening may not be obtained. Nailing on
steel plate to excessive depth may extremely
reduce the fastening force. Before nailing, adjust
the nailing depth properly.
In the nailing on the steel plate, the driver may be
•
clogged due to susceptibility to wear. When it is
worn, sharpen it or replace it with a new one.
Nail length
(mm)
32
38
45
50
9
Nailing of concrete
WARNING:
Use hardened nails only for concrete.
•
Using other purposed nails may cause serious
injuries.Do not nail directly on the concrete or do
not use to fasten directly the steel plate to the
concrete. Failure to do so may cause concrete
fragments to fly off or nails to strike back, causing
serious injuries.
When nailing, hold the tool so that it stands upright
•
to the driving surface.
Slanted nailing may cause concrete fragments to
fly off or nails to strike back, causing serious
injuries.
Do not use on the surface that objects hang from,
•
such as area where hangers for sewer pipe, dust
pipe etc. are set up
Choose and use nails so that the penetration amount
into concrete ranges 10 mm - 15 mm by referring to the
table below.
Wood thickness
(mm)
20
25
30
35
009189
Fig.16
CAUTION:
Use this tool only for soft concrete built up not so
•
long before. Using on the hard concrete may
cause nail bending or nailing to insufficient depth.
When the penetration amount into concrete comes
•
to more than 15 mm, nailing to the sufficient length
may not be obtained.
Cutting off the sheet
Fig.17
CAUTION:
Always disconnect the hose before cutting off the
•
sheet.
Tear off the output sheet in the direction of the arrow
when using the sheet collated nails.

MAINTENANCE

CAUTION:
Always disconnect the air hose from the tool
•
before attempting
maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Nail length Concrete
(mm) (mm)
32 Approx. 12
38 Approx. 13
45 Approx. 15
50 Approx. 15
to perform inspection or