Table of Contents
Advertisement
3.7 ELECTRICAL CONNECTIONS
This commercial equipment must
be properly grounded in accordance of
all current National, state and local codes.
Never remove the ground prong of the plug.
3.7.1 ELECTRICAL SUPPLY
The electrical voltage requirement is
listed on the data plate that is located on the
lower left side panel.
Make sure the voltage is within 10% of
the voltage listed on the steamer data plate.
Connection to any other voltage not
identified on the data plate will cause damage
to the components and is not covered under
warranty.
Grounding provides a path for electric
current to reduce risk of shock.
If provided with one, the plug must be
plugged into a receptacle that is properly
installed and grounded in accordance with all
National, State and local electrical codes or in
the absence of local electrical codes with the
National Electric Code, ANSI/NFPA 70, or the
Canadian Code, CSA C22.2 as applicable.
Under no circumstances shall the plugs
grounding prong be cut or bent to fit a
receptacle other than the one specified.
Do not use any adapters.
Any in-field modification made that
bypass the safety features of this equipment
will result in serious injury or death.
Any in-field modifications made without
written authorization from AccuTemp
Products, Inc. will void all written and oral
warranties
.
MP5032-2104
The XLR8 has been designed, manufactured
and tested to meet or exceed the demanding
standards of safety set forth by ANSI/NFPA
70. To to ensure that this high level of
safety is maintained in your installation, it is
important that you read and understand the
following information before attempting to
use the equipment.
3.7.2 ELECTRICAL REQUIREMENTS
Electrical requirements are listed on the
data plate located on the front right of the
control panel. All standard XLR8 are wired to
an internal power supply terminal and draw
power from the griddle.
If supplied with a 6ft (1.83m) cord and the
appropriate UL listed plug, the equipment
must be connected to the correct voltage
specified on the units data tag. Depending on
the rating listed on the data plate. Make sure
that the voltage at your supply receptacle
is within ± 10 % of the voltage listed on the
griddle data plate. Connection to any other
voltage may cause damage to components in
the commercial equipment. The equipment
plug must be used with the appropriate
receptacle.
3.7.3 GROUNDING INSTRUCTIONS
Grounding provides a path for electric
current to reduce the risk of shock. This
product is equipped with a power cord
having a grounding conductor and a
grounding plug. The plug must be plugged
into a grounded receptacle that is installed
and grounded in accordance with local
codes, or in the absence of local codes,
with the National Electric Code, NFPA 70, or
the Canadian Electrical Code, CSA22.2, as
applicable
XLR8 HEATED PLATEN
5
Advertisement
Table of Contents
