Table of Contents
Advertisement
3.3 OVERTEMP SWITCH
1. Follow typical safety protocol for electrical and work
space and tools. Lock out tag out.
2. Disconnect from power source.
3. Lower handle assembly.
4. Remove the controller cover
5. Loosely install controller cover assembly.
6. With one hand on the handle to prevent the arm
assembly from rapidly lifting up, remove the heater
cover 8-32 X 3/8" Truss head screws doing the ends
first then finish in the center of the heater cover.
7. Slowly raise the arm assembly to its max height,
leaving the lower half of the heater assembly laying
on the griddle surface.
8. Carefully move the insulation away from around the
o ending Overtemp switch to gain clearance to the
threaded end of the Overtemp switch.
9. Use a 3/8" wrench to back out the switch.
10. Apply a small amount of thermal compound to the
bottom of the overtemp switch where it will make
contact with the element.
11. Reverse procedure to reinstall.
12. Use permanent lock-tite on the #8-32 heater cover
screws when reinstalling.
3.4 MAGNETIC PROXIMITY SWITCH
1. Follow typical safety protocol for electrical and work
space and tools. Lock out tag out.
2. Disconnect from power source.
1. Follow typical safety protocol for electrical and work
space and tools. Lock out tag out.
2. Power unit down and unplug from receptacle.
3. Access control interior by removing two screws, one at
front of control box and one at rear.
4. Carefully lift the control box cover up, do not stretch the
wires attached the the underside of the cover.
5. Disconnect proximity switch wires from control board,
marking their location.
6. Remove two nuts holding proximity switch in place.
7. Thread wiring out through arm assembly to complete
removal of switch.
8. Reinstall in reverse order.
MP5032-2104
XLR8 HEATED PLATEN
18
Advertisement
Table of Contents
