Advertisement
OPERATION
After completing the Data Line (or Code) connections, power
up the unit (see Powering Up, next section). When the 2032
receives valid code through the Data Line or Control Code
inputs, the green DATA LED on the front panel illuminates.
If the green DATA LED is flickering, the code lines may be
backwards. Try reversing the black and white code lines.
If the DATA LED does not illuminate, check for proper
operation of the System. Check all connections. If all the
connections are as they should be and the 2032 still does not
operate properly, unplug the 2032, remove the top cover, and
check the DIP switch settings. Refer to the DIP switch
illustration on page 4.
If connected to a 1995 or 1996 System Data Line, all the DIP
switches should be in the OFF position. If connected to a
1650/1650A System Control Code line, the position for the
eighth DIP switch should be in the ON position.
Power Sources
The 2032 Alarm Responder does not contain an On/Off
Switch. The socket outlet shall be located near the equipment
and shall be readily accessible. The 120V units are supplied
with a pendant 3-wire cord and plug for mating to the
primary source outlet. The 230V units are supplied with a
Euro style IEC 320 type inlet. A suitable detachable cord
should be connected between the IEC 320 inlet and the power
source. The cord should conform to all national and local use
code requirements.7 There is a green PWR LED power
indicator, located on the rear panel, that illuminates when
power is applied.
2032 models are configured for 120V, 50/60 Hz or 230V,
50/60Hz primary power source as follows:
AD2032: 120V, 50/60Hz
AD2032-1: 230V, 50/60Hz
Powering Up
DO NOT CONNECT THE EQUIPMENT TO THE POWER
SOURCE UNTIL ALL CONNECTIONS HAVE BEEN
PROPERLY MADE.
Make all connections to the 2032, (Data Lines, Control Code
lines, and Relay connections) and set the DIP switches before
applying power.
If a valid code is being received, the green DATA LED will
illuminate and glow steadily. If it flickers there may be a
problem with the Control Input line.
5
OPERATION
Advertisement
