Advertisement
•
Drill 2 holes the wall 55mm apart vertically in the required location with regard to any
concealed wiring or pipework, use wall plugs if required and screw in two dome head
screws leaving the heads 4mm proud of the surface.
•
Locate the keyhole slots in the base of the light unit over the screw heads and ensure
the light is securely fixed.
•
Adjust the angle of the dummy camera head unit as required.
OPERATION
•
The motion sensor will turn on the light when movement is detected only in low light
environments.
•
After motion ceases to be detected, the light will
extinguish after 25 seconds.
MAINTENANCE
•
Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
SPECIFICATION
Power supply:
Material:
Light Source:
Output power:
Ambient light:
Sensor distance:
Sensor angle:
Time delay:
Product weight:
Product size H x W x D:
IP rating
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
4×AA batteries (NOT included)
ABS, PS
6×F5 High Brightness LEDs
50 lumen
<10LUX
0-5m
120°
25±2 sec (Auto-delay function)
208g
190×88×110mm
IP44
Made in China. PR2 9PP
Man Rev 1.0
Advertisement
