Setup; Control Switches; 8-Position Dip Switch - American Dynamics AD1273 CobraDome Installation And Operation Instructions Manual

SETUP

SETUP
This section describes the required settings for proper
operation of the AD1273. Before installing the AD1273,
determine the intended operating requirements and set the
related switches accordingly.

Control Switches

An 8-position DIP switch configures each dome for the
particular user-selected hardware. Two thumbwheel switches
identify the specific dome location within a Matrix Switching
System.
Both thumbwheel switches and the 8-position DIP switch are
mounted to the printed circuit board located on top of the
chassis (see Figure 3).
NOTE: Verify all switch positions before installing the
chassis into the chassis housing.
Switch Function
Camera Selection
Video Type
Motorized Lens
Automatic Light Control (ALC)
Line Lock
Not Used
Not Used
Not Used
Table 1 - DIP Switch Positions and Related Functions
DIP Switch Number
1
2
3
4
5
6
7
8

8-Position DIP Switch

An 8-position DIP switch labeled S1 configures each dome to
the particular type of hardware. The DIP switch is configured
at the factory, and only needs to be verified prior to
installation. The DIP switch is mounted to the printed circuit
board on top of the chassis frame (see Figure 3).
DIP switch positions and functions are described below and in
Table 1.
DIP Switch 1 - Set switch #1 in the OFF position for a
COLOR camera and the ON position for a
BLACK/WHITE camera.
DIP Switch 2 - Set switch #2 in the OFF position if using
NTSC standards and the ON position for PAL
standards.
DIP Switch 3 - Set switch #3 in the OFF position to ENABLE
the motorized lens and the ON position to
DISABLE the motorized lens.
DIP Switch 4 - Set switch #4 in the OFF position to ENABLE
the ALC and the ON position to DISABLE the
ALC.
NOTE:
DIP Switch 5 - Set switch #5 in the OFF position to ENABLE
the LINE-LOCK and the ON position to
DISABLE the LINE-LOCK.
NOTE:
DIP Switch 6 - Not used.
DIP Switch 7 - Not used.
DIP Switch 8 - Not used.
DIP Switch ON
B/W Camera
PAL
Disabled
Disabled
Disabled
N/A
N/A
N/A
4
The ALC default is OFF.
The LINE-LOCK default is OFF.
DIP Switch OFF
Color Camera
NTSC
Enabled
Enabled
Enabled
N/A
N/A
N/A
AD1273