Advertisement
POWER SOURCES
Power Sources
DO NOT CONNECT THE EQUIPMENT TO A POWER
SOURCE UNTIL READY TO "POWER UP". Make all
connections to the 2031 data line, or code input and relay
connections and set the DIP switches prior to power up.
The 2031 Switcher\Follower does not contain an On/Off
Switch. The socket outlet shall be located near the equipment
and shall be readily accessible. The 120V units are supplied
with a pendant 3-wire cord and plug for mating to the primary
source outlet. The 230V units are supplied with a Euro style
IEC 320 type inlet. A suitable detachable cord should be
connected between the IEC 320 inlet and the power source.
The cord should conform to all national and local use code
requirements.
Switcher\Followers are available in two models, depending
on the power source to be used:
AD2031: 120 V, 50/60Hz
AD2031-1: 230 V, 50/60Hz
Operating Indicators
A green POWER LED power indicator located on the rear
panel illuminates when power is applied.
When the unit is receiving valid code, the green DATA LINE
LED on the rear panel will illuminate and glow steadily. If it
flickers, there may be a problem with the Control Input line.
7
Advertisement
