Table of Contents
Advertisement
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the switch housing
screws found in the
bag. It does not
matter which two screw holes you choose.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.
Install bulbs into the
sockets. When necessary,
replace with bulbs of same
wattage.
Ceiling Bracket
Downrod
Assembling the Light Kit
2 of 3
Light Kit Screw
bag
2 of 3
Switch Housing
Screw
bag
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
Wiring
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
Installing the Glass
Tab
Notch
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Canopy
Blades
Insert the third screw,
found in the
bag, into place and then
tighten all three screws.
Turn the light kit counterclockwise until the
switch housing screws are firmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Glass/Bulbs
1886
1 of 3
Light Kit Screw
bag
hardware
1 of 3
Switch Housing
Screw
bag
8
Remote
Advertisement
Table of Contents
