Hanging The Fan - Hunter Overture Installation Manual

1886
Follow below if you are using the downrod that came
pre-assembled in your box. Need to install a longer or
shorter downrod? Check out the guide at the end of
this manual.
1
Remove the pre-installed
setscrew so that the
downrod can be inserted.
Hook the looped end of the cable over the
lag bolt so that the cable is between the
plastic washer and the outlet box.
5
Ceiling Bracket Downrod
Installing the Downrod
Hunter Pro Tip:
The ground wire attached to the
2 downrod is approximately 8 inches.
Pass all wires to one side of horizontal
bar in downrod assembly. Hand tighten
the downrod (at least 4–5 full turns)
until it stops. Trim the wires coming
from the fan so that 8-inches remain
coming from the top of the downrod.

Hanging the Fan

DO NOT PICK THE FAN UP BY THE CANOPY
OR WIRES. Place the downrod ball into the
slot in the ceiling bracket.
Installing the Secondary Hanging System
Tighten the loop then tighten the lag bolt using
a hex head ratchet socket wrench. Coil up the
Hanging Fan Wiring
3
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
excess cable.
Canopy Blades
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
NOTICE
If you have a different configuration
than shown or have a downrod
accessory, consult a qualified
installer and/or electrician.
Light Glass/Bulbs Remote