Section 1 Description; Introduction; General Description - Big Joe PDSR 30 Installation, Operation, Maintenance & Repair Parts

1-1. INTRODUCTION.

.This publication describes the 24 volt lift truck distrib-
uted by Big Lift LLC. Included are operating instruc-
tions, planned maintenance instructions, lubrication
procedures, corrective maintenance procedures and a
complete parts list with part location illustrations.
Users shall comply with all requirements indicated in
applicable OSHA standards and current edition of
A.N.S.I. B56.1 Part II.By following these requirements
and the recommendations contained in this manual,
you will receive many years of dependable service
from your PDSR lift truck
The model number will be found on the name plate
(Figure 1-1) along with the serial number, lifting capac-
ity, and load center. Figure 1-2
the trucks main components and controls.

1-2. GENERAL DESCRIPTION.

The self-propelled truck,
orts payloads up to 3000 pounds on rigid forks.
4 feet without changing the overall lift height. Then the
mast will start to rise. However, if the truck has an
optional load backrest, the backrest will raise above
the mast before the end of the full free lift.
The forward and reverse motion is controlled by either
of two controller levers mounted on the control
head.Stopping and turning is controlled by the steering
arm.Lift and Lower is controlled by pushbuttons on the
control head. The battery powered lift truck is quiet
and without exhaust fumes.
The reversible AC motor propels the lift truck in for-
ward or reverse direction throughout the available
speed range. The PDSR lift truck can be driven with
BL-PDSR 30-0319 - 03-07-2019
DESCRIPTION
shows the locations of
(Figure 1-2), lifts and transp-
SECTION 1
forks raised or lowered; however, the speed is restri-
cted when the platform is raised above a preset limit.
The model number will be found on the name plate
(Figure 1-1) along with the serial number, lifting capac-
ity, and load center.
the truck's main components and controls.
R6209
Figure 1-2 shows the locations of
Figure 1-1 Name Plate
1-1