Charging Batteries; Lubrication; Lift Chain Maintenance - Big Joe PDSR 30 Installation, Operation, Maintenance & Repair Parts

CHARGING BATTERIES

3-4.
Charging requirements will vary depending on depth
of discharge and temperature. Follow safety rules
when placing a battery on charge.
Proceed as follows:
1. Park truck at charging station with carriage low-
ered and turn the key switch off.
2. Check the condition of the AC cord and battery
cables. If there are any cuts in the cable, any
exposed wires, loose plugs or connectors, DO
NOT attempt to charge the batteries. Contact
appropriate personnel for repairs to be made.
3. Disconnect the batteries from the truck and con-
nect the batteries to the charger. Make sure
connectors are mated properly.
4. Connect the charger to the appropriate power
supply.
5. Follow the instructions for the charger being used.
Table 3-2
No. 1 Transmission oil- 85W-90
Transmission oil-10W-30 (NOTE)
No. 2 Grease-Lithium base, general purpose.
No. 3 Hydraulic oil-Heavy duty with a viscosity of 150 SUS foam suppressing agent and rust and
oxidation inhibitors
Hydraulic oil-Heavy duty with a viscosity of 100 SUS foam suppressing agent and rust and
oxidation inhibitors (NOTE)
No. 4 SAE 30 or 40 Engine lubricating oil.
BL-PDSR 30-0319 - 03-01-2019
Recommended Lubricants (See Table 3-3 for Application)
NOTE: USED ON COLD CONDITIONED TRUCKS

LUBRICATION

3-5.
Refer to Table 3-2 for the recommended types of
grease and oil. Table 3-3
3-1 identifies the items requiring lubrication.

LIFT CHAIN MAINTENANCE

3-6.
Fully raise and lower lift carriage while observing
chains as they move over chain sheaves. Ensure
chain is aligned and tracking properly and all links
are pivoting freely. With lift carriage fully lowered,
spray or brush on a film of SAE 30 or 40 engine oil
in conjunction with Figure
3-3