Advertisement
P R E-O P E R AT I O N C H E C K L I S T
4.0
Rules for safer operation
7,500 MAX. RPM
Verify that the lever is disengaged or released, and the Honda
5.5
Read and understand
engine switch and fuel valve lever are in the OFF position. Make sure
operator's manual before
using this machine.
blade is completely stopped.
Failure to follow operating
Instructions could result
in injury or damage to
equipment.
WARNING
CAUTION: Running the CC-100 generates heat in the engine, blade and
5400 MAX. RPM
blade guard. Do not touch these components without wearing proper heat
protecting work gloves.
C1 hazard Communication Sywems. L L L L C C
Figure 4 - Warning label - inspect blades before use
ury.
To avoid injury:
Always inspect saw
e with
5.6
Check for missing or loose bolts. Tighten loose bolts and replace
blades before use.
.
missing bolts before operating machine.
efore
Replace all cracked or damaged
ine.
blades.
Rotating blade
hazard.
Do NOT operate with
CAUTION: The blade depth is approximate and not exact. Many vari-
guard up.
Keep hands and feet
ables affect the exact blade depth such as the exact diameter of a worn
away.
diamond blade. If an accurate depth must be cut, install the blade to be
used with the engine in the OFF position. Place the CC-100 in a secure
position that allows the blade to overhang and be visibly measured at
s, including NICKEL. When used, serviced, cleaned, or maintained equipment could generate particulates
hese chemicals are known to the state of California to cause cancer and birth defects or other
full blade depth. An example would be blocking the wheels with the
n, visit
www.P65Warnings.ca.gov
engine in the OFF position and lowering the blade along side a street
curb. This will allow a measurement from the bottom of the blade to the
top of the curb.
WARNING: Breathable silica may be generated by use of this product.
Silica can cause severe and permanent lung damage, cancer, and other
serious diseases. Do not breath the dust. Do not rely on your sight
or smell to determine if the dust is in the air. Silica may be in the air
without a visible dust cloud. If air monitoring equipment for silica is not
provided by your employer at your work site, you MUST wear appropriate
respiratory protection when using or servicing the machine. Consult your
employer and OSHA regarding the appropriate respiratory protection.
Use only diamond blades (steel
centered diamond cutting-off
wheels) with this machine. RPM
rating on blade must exceed
machine max rpm rating. The use
of any other blade could result in
death or serious injury.
M M O O - - 7 7 4 4 6 6 - - 0 0 2 2 4 4 1 1
TO AVOID INJURY.
Always inspect saw blades be-
fore use. Replace all cracked
or damaged blades.
Engine exhaust
contains poisonous
c c a a r r b b o o n n m m o o n n o o x x i i d d e e g g a a s s . .
Breathing it could cause
death.
Operate machine in well
ventilated area.
Surface Prep
Division
P: 877-817- 6687 F: 813-621-7125
Visit us at www.ussaws.com
sales@ussaws.com
7
Advertisement
