Drilling And Assembling - BRP Sea-Doo 295 100 457 Instructions Manual

INSTRUCTIONS
Keep retainer plate inside (already trapped
NOTE:
in silicone) or flat washers, depending on vehicle.
Replacement parts are supplied with the new kit.
2 3
1
F18P06A
U-CLAMP HOOK ASSEMBLY
1. U-Clamp
2. Hook
3. Finish plate

Drilling and Assembling

NOTICE Proper understanding of the follow-
ing steps is of the utmost importance. Make
sure the instructions are understood before
starting to drill holes in the deck.
2010 and up - Applicable models
1. Remove decal.
ssi2010-005-004
Use the correct template for your water-
NOTE:
craft. Model names are indicated on template.
2. Precut and center hole template (attached to
the instructions) in circular flat recess on deck
(previous decal location) using tape.
Make sure to orient template correctly ac-
NOTE:
cording to reference lines. Vertical line must be
aligned with length of vehicle, upside pointing to-
wards bow.
4 / 11
ssi2010-005-005
HOLE TEMPLATE IN POSITION - GTX - RXT MODEL SHOWN
ssi2011-030-001_a
HOLE TEMPLATE IN POSITION - GTI AND GTS MODEL SHOWN
3. Punch target mark.
ssi2010-005-006
Up to 2009
4. Using a square set at 61.6 mm (2-13/32 in), start
at center between both U-clamp holes (respect
the angle of the body) and project the most cen-
ter position on the rear hull.
Instruction Sheet P/N 487 800 755