Parts To Be Installed; Preparation - BRP Sea-Doo 295 100 457 Instructions Manual

PARTS TO BE INSTALLED

PARTS TO BE INSTALLED
ssi2009-001-001_a
ITEM P/N
P1 291 002 995
P2 291 002 553
P3 291 002 712
P4 291 002 711
P5 230 060 060
P6 232 561 200
P7 234 062 600
P8 293 050 001
P9 293 830 037
P10 205 484 060
P11 232 581 200
P12 234 081 600
P13 250 200 011
P14 269 501 166
P15 219 902 983
† 219 903 138 Warning label (French)
INSTRUCTIONS

Preparation

1. Remove or lift seat.
Up to 2009
2. Remove side bolts from both sides of grab han-
dle; keep bolts and flat washers for reuse.
2 / 11
DESCRIPTION QTY
Handle (ski pylon)
Support
Lateral Arm (RH)
Lateral Arm (LH)
M6 x 100
Hexagonal Bolt
M6 Elastic Stop Nut
M6 Flat Washer
Flat Washer
Rubber Washer
M8 x 40 Rounded
Head Bolt
M8 Elastic Stop Nut
M8 Stainless
Flat Washer
M8 Stainless
Flat Washer
Nut Housing
BRP Logo Decal
Instruction Sheet P/N 487 800 755
F18P03A
1
1. Grab handle side bolts
1
Lift coolant reservoir out of its bracket and
NOTE:
1
set it aside in order to ease removal of right for-
ward bolt.
1
3. Remove two M8 x 45 hexagonal bolts that are
1
retaining grab handle at rear center; discard
their elastic stop nuts but keep inside and out-
5
side flat washers with bolts for reuse.
2 4. Remove grab handle and set aside.
2
2
6
8
6
2
4
1
F18P04A
1
1. Grab handle center screws M8 x 45
5. Cut locking tie around upper exhaust hose (ex-
cept on RXT™-X™ models).
6. With a bungee cord, pull and secure hose for-
ward; this will provide more working space.
7. For vehicle with bailer hoses secured to
U-Clamp retainer plate, cut locking tie to un-
hook and set bailer hoses aside.
1
1