Safety Precau Ons; Installa On; Local Setup; Moun Ng - Triax GPV 150 Series User Manual

Installa on

2.3 Safety
BEWARE:
You must adhere to the Safety Precau ons of EN 60728-11
precau ons
•
•
•
•
•
3. Installa on
Mount the Amplifier...

3.1 Local setup

•
•
•
•
•
•
Wall moun ng:

3.2 Moun ng

Fig. 1 Moun ng
English
Before you start working on the installa on, turn off Mains Power to the circuit.
Only let an authorized Elecctrician do the Mains power plug installa on if needed.
Never do Installa on or Repair during Thundr Storms.
Always ground the network using the Grounding Terminal of the unit (Diameter
2
min. 4 mm ) or using the Building Groun ng Terminal..
Cau on: On remote fed Amplifiers, a voltage of 65 V is present on the Input.
Please only open the GPV 150 DL when the RF-cables at In– and Output has been
connected.
Before you start working on the installa on, turn off Mains Power to the circuit!
Observe the safety precau ons!
Horizontal, free on the wall and so that the convec on cooling of the unit
is not compromized.
On non-flammable material (Concrete or Brick Wall)
In a dus ree environment, protected against moisture and fluid.
(Drop– and spraywater)
Not in a spot with direct Sun radia on (e.g.. On the Roof)
Not directly along with Heat Sources (e.g. Hea ng Room)
In compliance with the highest allowed working Temperature
(measured at the Airflow under the Amplifier)
Fasten the a ached moun ng taps at the back of the amplifier, see D (Screws a a-
ched)
Fasten the amplifier to its measurements (Distance between holes 194 mm, see
Fig. 1) on the wall
Create a grounding poten al using the screw A and a sufficient fi ed and stable
cable (diameter min. 4 mm
Connect the RF-Input B and the RF-Output C. Make sure you get perfect
connec on between Coax cable and Connector.
Turn on the Mains Power to the circuit again.
2
)
13
GPV 150 Serie