Managing Alarms; Cable Removal; Remerchandising - MTI CX FLEX 4A Product Manual

MANAGING ALARMS

1 To silence an alarm, hold the user card over the RFID icon. To disarm after silencing an alarm, hold the user card over the
RFID icon again (2 + 4 beeps). Alarm events on any port will trigger an alarm, and the LEDs for the affected individual port
or ports will flash red/white along with the system (side) LEDs. Other armed ports LEDs remain white.
NOTE: If the issue causing the alarm is corrected while the system is
still alarming, holding the card over the RFID icon will immediately
re-arm the system (2 beeps).
If the issue causing the alarm is resolved after silencing the alarm,
the system will automatically re-arm after 1 minute without using the
RFID card or re-arm immediately by holding the User Key over the
RFID icon. (2 beeps).
2 + 4 beeps indicates card was successfully read (2 beeps), but can't
arm the system or all ports that are in use (4 beeps).

CABLE REMOVAL

1
Insert a corner of the RFID card into the slot and press
down until the cable detaches.

REMERCHANDISING

1
From an armed state, place the
User Key over the RFID icon to
disarm the system. LED will be
flashing white. Then remove the
cable.
www.mtigs.com | T:800.426.6844
2
2
Remove the cable.
2 Insert new cable until it clicks.
click
CX FLEX™ 4A PRODUCT MANUAL
3 Re-arm by holding user card over
RFID icon or system will auto-arm
after 1 minute.
MTI P/N 063-00318 rev A ©2019 MTI All Rights Reserved
5