Software Requirements; Safety Precautions; Unpacking The Package; Installation Instructions - Mellanox Technologies ConnectX-4 Lx User Manual

Please refer to the Specifications

All cards in the system should be planned with the same airflow direction.

3.2.2 Software Requirements

• See Operating Systems/Distributions
• Software Stacks - Mellanox OpenFabric software package MLNX_OFED for Linux, WinOF-2 for Windows,
and VMware. See the

3.3 Safety Precautions

The adapter is being installed in a system that operates with voltages that can be lethal. Before opening the case of the
system, observe the following precautions to avoid injury and prevent damage to system components.
• Remove any metallic objects from your hands and wrists.
• Make sure to use only insulated tools.
• Verify that the system is powered off and is unplugged.
• It is strongly recommended to use an ESD strap or other antistatic devices.
• Shut down your system if active; Turn off the power to the system, and disconnect the power cord. Refer to the
system documentation for instructions. Before you install the ConnectX-4 Lx card, make sure that the system is
disconnected from power.

3.4 Unpacking the Package

Check the adapter for visible damage that may have occurred during shipping. Please note that the cards must be placed
on an antistatic surface.

Please note that if the card is removed hastily from the antistatic bag, the plastic ziplock may harm the EMI
fingers on the networking connector. Carefully remove the card from the antistatic bag to avoid damaging the
EMI fingers.

3.5 Installation Instructions

This section provides detailed instructions on how to install your adapter card in a system.
18
section for airflow numbers for each specific card model.
section under the Introduction section.
Driver Installation section.
Mellanox Technologies