Specifications - Teledyne CombiFlash Torrent Installation Manual

Hide thumbs Also See for CombiFlash Torrent:
Table of Contents

Advertisement

CombiFlash Torrent Installation Guide

1.3 Specifications

Table 1-1 CombiFlash Torrent Module Specifications
Sample size:
RediSep Rf column
sizes:
Flow rate:
2
Maximum pressure
Detection:
Gradient:
Gradient accuracy:
Sample injection:
Controller:
Software:
Fraction collection:
Solvent management:
Module dimensions:
(W x D x H)
Module weight:
Operating voltage:
Safety and sample
security:
Ambient Temperature
Humidity (when
connected to power)
Certification:
Electrical Safety per EN 61010-1
Installation Category
Maximum Altitude
Pollution Degree
Note 1. All specifications are subject to change.
Note 2. For columns undetected by RFID, the max pressure is limited to 50 psi.
1.4 Safety
Before installing, operating, or maintaining this equipment, it is imperative that
all hazards and preventive measures are fully understood. While specific hazards
may vary according to location and application, take heed in the following general
warnings:
0.5 to 300 grams
80 gram to 3 kilogram
50 – 1000 mL/min
:
6.89 bar (100 psi)
200 – 400 nm (200 – 800 nm optional) with single,
dual, or All-wavelength Collection.
Accepts external detector input.
Binary, high pressure solvent mixing with linear, step,
or isocratic capability. Two solvent inlets.
<2% full scale from 0.2 to 1.0 liter/min.
Automated injection with options of solid load
cartridges, liquid load, or direct injection.
26.7 cm (10.4 inch) touch screen
Supports remote control via Windows® PC.
On-screen method development and control with
PeakTrak software
Up to four fraction collectors, fractionation valve, or
manual collection
Patented, active level sensing for inlet and waste
containers
47 x 43.5 x 71.4 cm
18.5 x 17.9 x 28.1 inches
65 lbs (29.5 kg)
100 VAC 50 Hz, 2 amperes
117 VAC 60 Hz, 2 amperes
234 VAC 50 Hz, 1 ampere
(±10% of the region's nominal line voltage)
Static-dissipative tubing throughout,
Vapor sensor for internal leak detection,
Overpressure sensor,
Active solvent and waste level sensing,
Audible alarm when user intervention is required.
20 to 40°C (maximum temperature must be at least
15°C below the boiling point of the solvent)
95% relative humidity maximum at 20 to 40°C
CE
II
2000 meters
2
1

Advertisement

Table of Contents
loading

Table of Contents