Extron electronics SYSTEM 8 Plus Installation Instructions page 2

Toshiba TLP Installation
Toshiba TLP 710U/711U Projector Configuration
__________ Before changing anything, remove the AC power cord to the System 8/10 P
Config Model
as
Toshiba 710U/711U 0
_ RS5 is for RGB switching
delay. See page 3-4 for
more information on switch
functions.
______ Secure the screws on all D connectors
Extron • System 8/10 P
LUS
Verify that the System 8/10 P
710U/711U projector. The general setup is explained on page 3-4 and the switch
settings for the projector are repeated below.
1. Use a small screwdriver to remove the access cover from the System 8/10 P
front panel. See bottom of page 3-3. The label on the back of the access cover
also has the configuration information.
to verify that the main power is OFF; also turn the projector power OFF.
2. Set the switches as follows:
Rotary Switches Cable
RS1 RS2 RS3 RS4 J2/J3
0 E 3
RS2
RS5 RS2
RS1
3. Use a grease pencil (or other rub-off marker) to mark the space on the label next
to "Toshiba 710U/711U".
4. Locate the switcher's Address DIP switches on the rear panel, lower right. Unless
this is part of a host/peripheral system, set #3 and #5 to the up position and the
others down. See illustration to the left.
Use the illustration on the next page to do the following steps.
5. Connect the Comm Adapter's 9-pin male connector to the 9-pin female "RS-
232C" connector on the rear panel of the projector.
6. Connect the CC-50' (or CC-100') cable from the 9-pin male connector of the
Comm Adapter to the 15-pin HD "Projector Control" port located on the rear
panel of the System 8/10 P
7. Connect the BNC (RGBS) cables from the System 8/10 P
projector's 15-pin "RGB 1 IN" connector. When using S-Video, connect the S-
Video cable to the "VIDEO 1 IN" connector of the projector. If using Composite
Video, connect the cable to the projector's "VIDEO 2 IN" connector.
8. Apply Main Power to the System 8/10 P
Main Power LED should light. Apply power to the projector.
9. Return System 8/10 P
• User's Manual • P/N 68-427-01 Rev. C
Configuration and Connections
is already configured for the Toshiba TLP
LUS
SW15 Settings
1 2 3 4 5 6
↓ ↓ ↑ ↓ ↑
J2
-
ON
SW15 DIP Switch
RS1
Configured For:
RS-232
.
LUS
by connecting the power cord. The
LUS
and projector to normal operation.
LUS
Comm
7 8 9 10 Adapter
↓ ↓ ↓ ↑ ↓
26-474-01
RS3 RS4
outputs to the
LUS
LUS
LUS
RS3
RS4
Page 2