Recharging The Battery; Used Batteries; Assembling Instructions - Grizzly ART 4032 Lion Translation Of The Original Instructions For Use

GB
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Recharging the battery

Charge the battery (16) when the
last LED of the charge indicator
(17) lights up in red.
One of the charge status indica-
tor LEDs (17) of the battery (16)
flashes green while charging. For
each section of the battery (16) that
is already charged, a green LED
lights up. When all three LEDs of
the charge status indicator (17) light
up in green, the battery (16) is fully
charged.
1. Remove the battery (16) from
the appliance, as necessary.
2. Inser the battery (16) in the
charging compartment of the
battery charger (20). It will audi-
bly snap in.
3. Plug the battery charger (20) into
a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (20) from the mains.
5. Press the release button (
on the battery (16) and pull the
battery out of the battery charg-
er (20).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
66
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Assembling instructions

Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
To put on the protective cover:
1. Place the protective cover (14)
on the motor head (10) and
screw it down with the 2 Phillips
screws.
To put on the auxiliary handle:
2. Pull the ends of the auxiliary
handle (5) to extend the han-
dle and slide it over the handle
holder
3. Lift the handle unit (22) to the
same height. Screw the additional
handle (5) to the handle unit (22).
Setting the line:
4. The line coil is already pre-
mounted. Adjust the line to the
desired length.
18) Inserting the rechargeable
battery:
5. To insert the battery (16) into the
device, push the guide groove
(19) of the battery into the device
along the guide rail (21). You
should be able to hear it lock into
place.