Titan IMPACT Series Quick Start Manual

Any piece of equipment can be dangerous if not operated properly. YOU are responsible for the safe operation of this equipment. The operator must carefully read and
follow any warnings, safety signs and instructions provided with or located on the equipment. Do not remove, defeat, deface or render inoperable any of the safety devices
or warnings on this equipment. If any safety devices or warnings have been removed, defeated, defaced or rendered inoperable, DO NOT USE THIS EQUIPMENT!!!
HIGH PRESSURE SPRAY CAN CAUSE EXTREMELY SERIOUS INJURY. THE PRESSURE STREAM CAN PIERCE SKIN, DAMAGE EYES, BURST
EAR DRUMS. USE EXTREME CAUTION
NEVER TOUCH A LEAKING HOSE, IT CAN PIERCE SKIN. SHUT THE UNIT DOWN AND RELIEVE THE PRESSURE BEFORE HANDLING IT. If
any fluid ever appears to penetrate the skin, get EMERGENCY CARE AT ONCE!
This 120-volt equipment requires a grounded outlet, do not modify plug.
This Paint Sprayer is for Water Based Paints & Stains Only! Spraying any other type of material through it is considered misuse and Voids the Equipment Protection
Plan. The Customer is liable for all damages caused by misuse. Never Spray Elastomeric Coating, Roof Coat, Driveway Sealer, Block Filler, Oil Base Stains or Paints
through this unit.
1. Never put your hands or other body parts in front of spray gun. Never point the gun at your body or anyone else. Never put your hand or fingers over the spray tip.
Always wear safety clothing, gloves, and safety glasses.
2. Never attempt to change or clean spray tip without first relieving the pressure.
3. Keep the gun trigger safety level locked when not spraying.
4. Never try to stop leaks with your hand or body. Never wipe off build up around spray tip. Always remove the tip from gun to clean it (after relieving pressure)
5. If any fluid ever appears to penetrate the skin, get EMERGENCY CARE AT ONCE!
6. Before turning pump on, lock the gun trigger in the "OFF" position and check all connections.
7. Check operation of gun safety devices before each use. Check all hoses and connections.
8. If spray tip clogs while spraying, engage the gun safety latch and release pressure before cleaning.
9. Always use a face filter mask AND safety glasses while operating.
10. Never leave sprayer unattended with pressure in the system.
11. Never operate in an enclosed building, area, or room unless adequate ventilation is provided.
12. Do not spray paints with flashpoints below 69.8 Fahrenheit. Sprayer could ignite and cause fire or explosion.
13. Never spray in the vicinity of open flame, pilot lights, electrical outlets, or any other source of ignition.
14. Never wash an electric motor driven unit, nor operate in the rain or damp areas.
15. Always ensure that the motor switch is "OFF" before plugging the unit in.
16. Never allow paint hose to become kinked, or vibrate against rough or sharp surfaces.
17. All electrical equipment must be grounded to avoid electrocution.
18. Do not operate sprayer while standing on any unstable surface or platform.
If the person receiving this handout will not be the user of the equipment, forward these instructions to the operator.
If there is any doubt as to the operation or safety of the equipment,
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY OR DEATH

WARNING

AIRLESS PAINT SPRAYER
<<< DANGER >>> <<< DANGER >>>
$$$$$ Cleaning Charge $100.00 Minimum. Plus Parts $$$$$

IMPORTANT SAFETY RULES TO FOLLOW

DO NOT USE!!! CALL A TOOL SHED IMMEDIATELY!!!
<<< DANGER >>>
National Poison control Hotline1-800-222-1222