Charging Dana; Dana First Time Set Up - Alphasmart Dana Getting Started Manual

Charging Dana

Dana comes with a rechargeable battery that recharges whenever it
is connected to its AC Adapter or to the computer via a USB cable
(charging will only occur while the computer is on). You can also
use standard AA alkaline batteries (not included).
You will need to connect Dana to the AC adapter for four hours or
the computer for eight hours to get a full charge. Use the AC
adapter that comes with Dana, or one that meets the following
specification: Input: AC 120v 60Hz 9W Output: DC 7.5V 500
mA. A fully charged Dana should run for over 25 hours.
Using the AC adapter
1. Connect the AC adapter to the Dana AC port.
2. Plug the AC adapter into any AC current outlet.

Dana first time set up

1. Press the on/off key to turn on Dana.
2. Follow the on screen instructions to calibrate the Dana screen
4 Dana Tour
Important: The version of Palm Desktop Software
that comes with Dana must be installed before
connecting Dana to a computer.
and set the current date and time.
Note: If Dana does not turn on, see "Frequently
Asked Questions" on page 64 for troubleshooting
suggestions.
Important: For users outside the United States,
choose the same language for Dana and Palm
Desktop software. Choosing a language that does
not match the Palm Desktop software is not