Rear Wheel - HERO Passion Pro Manual

Tighten the axle nut.
î
Axle nut torque: 5.4 Kgf-m
Adjust the brake (page 42).
î
After installing wheel, apply the brake
î
several times and check for free wheel
rotation when released.
FRONT WHEEL REMOVAL
Disc Type (Cast wheel version)
Raise the front wheel off the ground.
î
(1) Speedometer cable (2) Tab (3) Axle nut
Remove the speedometer cable (1) by
î
pressing the tab (2) & then pull out the cable.
Remove the axle nut (3).
î
Remove the axle then remove the wheel.
î
Assemble in reverse order of removal.
î
Axle nut torque 5.0-6.0kgf-m.
WARNING
Do not operate front brake lever when the
wheel is removed.
REAR WHEEL REMOVAL
(Spoke/Cast wheel version)
Raise the rear wheel off the ground.
î
3
2 1
Remove the rear brake adjusting nut (1)
î
and disconnect the brake rod (2) from the
brake arm (3) by pushing down the brake
pedal. Disconnect the brake stopper arm
(4) from the brake panel (5) by removing
split pin (6) and lock nut (7).
Remove the axle nut (8) and pull out the
î
rear axle (9). Remove the wheel.
3
1
1
(1) Rear brake adjusting nut (2) Rear brake
rod (3) Brake arm (4) Brake stopper arm (5)
Brake panel (6) Split pin (7) Lock nut
43
5 2 4
7
3 5 2
7 6 4
6