Syba SY-ENC50122 User Manual page 4

3. HDD Installation Instruction
(Please do not connect the power supply while installing the hard drive.)
3.1 ： 3.5-inch hard drive installation
1. Touch the protruding position on the top of the panel
with your fingers. Pull out the magnetic panel and
place it properly.
2. Pull out the tray by pushing down on switches in the
middle with your thumb and index finger.
3. The 3.5-inch hard disk in the extraction box is
installed without screws. Please remove the fixing
tabs on both sides of the extraction box. Put the hard
disk in the extraction box correctly, and make sure
that the screw holes at the bottom of the hard disk
are placed in the positioning posts of the extraction
box.
4. Firmly push the side clamps back into place making
sure the HDD screw holes are lined up with the
screw holes in the tray.