Table of Contents
Advertisement
4.3
Settings
Start with the folder "Settings" to set up the general settings and information of the TDcH compact headend.
4.3.1
IP address of this interface:
This is the IP address of the Management port
(Ethernet 1) of the compact Headend.
It may be necessary to specify specific IP
addresses for the headend to avoid network IP address conflicts.
Note:
If a PC is connected direct to the Management port with an Ethernet cable, the network address of the PC
has to be in the same range as the compact headend.
The TDcH management port IP addresses can be reset to factory default settings if required. This is done via
the reset button on the headend unit.
4.3.2
System reset
The following reset functions are available:
1. When the reset button is pressed (during
start up) and until the LED blinks green,
then the system resets to factory defaults.
2. When the reset button is pressed (during start up) until the LED blinks red, then the system starts in recovery
mode.
4.3.3
Subnet Mask
This is the Subnet Mask for the network the Management Port is connected to.
EN
16
TDcH Compact Headend
Advertisement
Table of Contents
