3.5
Device overview
3.6
Connecting the device
•
Connect the SAT IF inputs to the corresponding outputs of an LNB or multi switch. Make sure that all inputs
have the same level and are in the required level range!
•
Connect the attached main cable to the IEC connector.
•
Connect the mains cable to a mains socket with protective conductor connection. Thereby note the voltage
specified on the device.
This device has no power switch and starts immediately after connecting the operating voltage.
•
Configure the device as described in the chapter "Installation & Easy Setup"
•
If the programming is finished connect the RF output to the cable network.
4 Installation & Easy Setup
4.1.1
Static IP address
A static address must be used on the computer you use to configure the headend. Refer to the computer's operating
software documentation for assistance on using static IP addresses.
4.1.2
Physical connection to headend
Connect a Cat5e shielded cable or better between the
computer's network port and the management port on the
headend.
Note:
Please use Ethernet port 1 to connect your PC to the
headend
Ethernet port 2 is reserved for further use.
EN
10
TDcH Compact Headend