Preparing To Install Your Dishwasher - Insignia NS-DWR3SS1 Installation Manual

Preparing to install your dishwasher

Parts supplied:
Wood screws (4)
Tools needed:
Phillips screwdriver
Flashlight
Measuring tape
Safety glasses
Materials needed (kit purchased separately):
90° Elbow, ferrule, and compression nut. (3/8
NPT external thread on one end. The other end
should be sized to fit the water supply line.
New installations only
Strain relief (for
electrical connections)
Electrical cable or power
cord (See Electrical
Requirements section)
4
Top mounting clips (2)
1/4 in. and 5/16 in.
Nut driver
Gloves
Bucket
New installations only
Tubing cutter
Teflon thread
seal tape
Hot water line (min.
3/8 in. copper) kit
Not included in kit
Waste tee for
Hand shut-off
house plumbing
valve
(if applicable)
www.insigniaproducts.com
Hose clamp
Drain hose
Level
Adjustable wrench
Hole saw set
Three Wire nuts (UL listed)
(two included in kit)
"T"connection
Screw-type hose clamps
Coupler for extending
drain line (if applicable)
Flat blade
screwdriver
Drill and bits
Garden hose
connection
Air gap (if
required)