Advertisement
Intellectual Property & Copyright Notice
©2010 by ABB Inc., Totalflow Products ("Owner"), Bartlesville, Oklahoma
74006, U.S.A. All rights reserved.
Any and all derivatives of, including translations thereof, shall remain the
sole property of the Owner, regardless of any circumstances.
The original US English version of this manual shall be deemed the only
valid version. Translated versions, in any other language, shall be
maintained as accurately as possible. Should any discrepancies exist,
the US English version will be considered final. ABB is not liable for any
errors and omissions in the translated materials.
Notice: This publication is for information only. The contents are subject
to change without notice and should not be construed as a commitment,
representation, warranty, or guarantee of any method, product, or device
by Owner.
Inquiries regarding this manual should be addressed to ABB Inc.,
Totalflow Products, Technical Communications, 7051 Industrial Blvd.,
Bartlesville, Oklahoma 74006, U.S.A.
Introduction
The following start-up guide is designed to assist the user in the start up
of the XFC
(flow computer) or XRC
G4
start-up guide, however, is primarily intended for gas orifice applications.
Using this guide in conjunction with other drawings and documentation
that accompany the user's order should result in a smooth installation. If
there are additional questions that are not answered by this guide or
other provided documentation, the user needs to call their local Totalflow
representative or call the number listed on the back page of this guide.
If the user is familiar with the XSeries products, the XFC
similar fashion. While the components on the circuit boards are different,
the pin outs, jumpers and connector placements are identical.
Installation and Start-Up Sequence
HINT: The following steps represent the recommended start-up
sequence. As a result, some of the steps do not go into great
detail either because detail is not needed or because more
information is available later in the guide. As such, the user is
encouraged to scan through the start-up guide before beginning
the installation.
Step 1
Physical Mounting and Piping
1A
Unpack the equipment, and inspect for damage and missing or
incorrect components. The user will then need to ascertain
where to mount the unit.
2
(remote controller) series. The
G4
will install in a
G4
Advertisement
