Adjusting Additional Audio Settings For A Zone; Power Options; Source Settings; Update Options - Garmin FUSION MS-RA210 Owner's Manual

Marine stereo
Table of Contents

Advertisement

Adjusting Additional Audio Settings for a Zone

1 Select
> SETTINGS.
2 Select ZONE.
3 Select a zone.
4 Select one or more options:
• To limit the maximum volume output of this zone, select VOLUME LIMIT, and adjust the level.
• To adjust the right and left speaker balance of this zone, select BALANCE, and adjust the balance.

Power Options

Select
> SETTINGS > POWER OPTIONS.
POWER SAVE: Disables the LCD backlight after one minute of inactivity to save battery power.

Source Settings

Select
> SETTINGS > SOURCE, and select the name of the source you want to configure.
NOTE: This menu contains system-wide source settings. Most sources also have source-specific settings. See
the sections of this manual for each source for more information about source-specific settings.
Not all options are available for every source on the stereo.
SOURCE ENABLED: Enables and disables the source on this stereo. You may want to disable sources that
will never be used on the stereo so they no longer appear on the source-selection screen.
SOURCE NAME: Changes the name of the source as it appears on this stereo.

Update Options

Select
> SETTINGS > UPDATE.
Do not turn off the device or disconnect the power during a software update. Turning off the power during a
software update may cause the device to become unresponsive.
NOTE:
• You can update the device software using a USB flash drive
Drive, page
23).
• The device may restart a few times when updating. This is normal.
• You can program only newer versions of software on the device.
STEREO: Updates the stereo using a valid software update file on a connected USB flash drive
Software Using a USB Flash Drive, page
NRX REMOTE: Updates an optional NRX remote connected to the NMEA 2000 port or NMEA 2000
DAB MODULE: Updates an optional DAB module connected to the SIRIUS XM port.
FACTORY RESET: Restores all settings to the factory default values.
20
NOTICE
(Updating the Software Using a USB Flash
23).
(Updating the
®
network.
General Settings

Advertisement

Table of Contents
loading

Table of Contents