Adjusting The Power-On Volume Limit; Disabling A Zone; Setting A Zone Name; Linking Zones - Garmin FUSION MS-RA210 Owner's Manual

Adjusting the Power-On Volume Limit

By default, when you turn on the stereo, the system automatically reduces the volume to level 12 if it was
louder than that when you turned it off. You can adjust this limit if you want to retain a louder volume or limit to
a lower volume when you turn on the stereo.
NOTE: This setting affects all zones on the stereo.
1 Select > SETTINGS.
2 Select ZONE > POWER ON VOLUME LIMIT.
3 Adjust the volume limit.

Disabling a Zone

You can disable an unused zone and remove it from the audio level pages. When a zone is disabled, you
cannot change any of the settings for that zone. You cannot disable zone 1.
1 Select > SETTINGS.
2 Select ZONE.
3 Select a zone.
4 Select ZONE ENABLED to clear the check box.

Setting a Zone Name

You can set a name for a speaker zone to make it easier to identify.
1 Select > SETTINGS.
2 Select ZONE.
3 Select a zone.
4 Select ZONE NAME.
5 Use the on-screen keyboard to enter a name, and select

Linking Zones

You can link zones 1 and 2 to keep the volume levels synchronized. Adjusting the volume of either of the linked
zones affects both zones.
1 Select > SETTINGS.
2 Select ZONE > ZONE 2 > LINK TO ZONE 1.
NOTE: After zones 1 and 2 are linked, you cannot adjust the volume of each zone individually.

Adjusting the Subwoofer Filter

You can use the subwoofer filter setting to control the subwoofer cutoff frequency for each zone, which can
enhance the blend of the sound produced by the speakers and the subwoofer. Audio signals above the
selected frequency are not passed to the subwoofer.
NOTE: If a DSP setting has been applied to the zone using the Fusion-Link app, this setting cannot be changed
on the stereo.
1 Select > SETTINGS.
2 Select ZONE.
3 Select a zone.
4 Select SUB. FREQ..
5 Select a frequency.
General Settings
.
19