Troubleshooting - TGA Minimo Autofold Operating Instructions And Owner's Handbook

Bodywork
You can clean the plastic bodywork of your scooter by lightly washing it with clean soapy water.
Car polish can be used to keep the paint and bodywork in pristine condition. Do not use
abrasive cleaners or strong detergents as this will fade the colour. Do not pressure wash.
Motor Brake
You can check if the motor brake is functioning correctly by testing, if you can push your
scooter when it is switched off or switched on with the speed control throttle in the neutral
position. If your scooter can be pushed when as described above, the motor brake may be
faulty.
Care! Warning
If this is the case do not use your scooter and contact TGA or an approved mobility specialist.
You can also test this when driving your scooter, if you let go of the speed control lever it
should lose speed very quickly. If you notice a change in the normal stopping time/distance
you should also contact TGA or an approved mobility specialist.
DO NOT operate your scooter in extreme weather conditions i.e. very heavy rain.
DO NOT drive through deep water. This could damage the main electronic controller, or other
electronics.
DO NOT store your scooter in damp conditions. This may affect the electronics if left for very
long periods of time
DO NOT do not hose down or pressure wash your scooter. Water could be forced into the
electronics and cause permanent damage.

TROUBLESHOOTING

If your scooter will not start, check the following:
Make sure the 'on' button has been pushed and the blue light is showing. If it is then the battery
condition indicator will be displayed, if it is showing empty then recharge batteries.
Check parking brake is released
If the battery condition indicator fails to operate when the scooter is on, check the
following:
Make sure your battery charger is not plugged in to the wall outlet, this will prevent your scooter
driving.
Check parking brake is released
Check the battery pack connection
If your scooter will not charge, check the following:
Check the lights on your battery charger are on and that the charger is plugged into a working
wall socket.
Check your battery charger is connected to your Minimo charge socket correctly
Care! Warning
If you find for any reason your scooter does not reduce speed when you let go of the speed
control lever, press the power button to stop. This operation should only be carried out as an
emergency.
14