Outbound 081-3852-0 Operating Instructions Manual page 9

TM
12. Carefully slide the Vertical Legs 3 up through the belt that runs
around the middle of the pool.
Tips: For smaller pools without a belt, slide the vertical legs up
through the sleeves on the pool wall.
3
14. Go around and check all fittings, legs, and beams are
properly installed and secured in place. Make sure the
drain fitting is plugged securely and the cap is in place.
15. Fill up the pool with about 1" (2.54 cm) of water. Stop filling and smooth out all wrinkles from the pool floor, working from the centre outwards, so that
it fills evenly.
Note: If more than 1 to 2" (2.54 to 5.08 cm) of water collects on any one side before the pool starts filling in the centre, the pool is not level
enough, and must be corrected.
16. Install the filtration system as per its instruction manual.
17. Continue to fill the pool to approximately 8" (20.32 cm) below the top rim.
NOT FOLLOWING THE STEPS ABOVE WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY LEAN
TO ONE SIDE AND COLLAPSE (SEE PICTURE). YOUR POOL SHOULD BE STRAIGHT AND VERTICAL TO THE
GROUND. IF YOUR POOL IS LEANING AT ALL, THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO
START OVER.
FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE THE POOL TO COLLAPSE AND WILL VOID
THE WARRANTY!
IMPORTANT: BEFORE ADDING WATER TO YOUR POOL YOU MUST INSTALL THE POOL WALL
FITTINGS OR ENTIRE FILTRATION SYSTEM FIRST. BEFORE ADDING WATER TO YOUR POOL
FOLLOW THE INSTRUCTIONS BELOW.
If your pool included openings or you are going to purchase a filter pump system, position the Suction & Return fitting locations so they are 10 to 21' (3-6.4 m)
from the electrical outlet you plan to use for the pool pump.
If your pool came with fittings - Install both the Suction and Return fittings to the pool wall before filling the pool.
ASSEMBLY INSTRUCTIONS
3
13. Look through the hole in the T-fitting, as you insert the Vertical
Leg rotate it until the buttons align with the holes and pop out,
locking the Vertical Leg in place. Do this for all Vertical Legs.
Note: Each vertical leg has a V-Shaped
Spring Pin
extra included with your pool parts.
pre-installed. There is one
8
9