Parts List; Assembly Instructions - Outbound 081-3852-0 Operating Instructions Manual

TM
1
Above-ground Pool Pool Liner
Pool Size Part # Qty.
16' x 48" (4.9 m x 122 cm) P4V016485099 1
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING
- DO NOT overfill the pool and/or allow people to lay over or sit on the pool wall - DOING SO CAN CAUSE PERMANENT INJURY!
DRAIN the pool to the proper level after a heavy rain.
TIP:
It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for about 2 hours prior to installation. This will help to ensure a
wrinkle-free fit because the pool material will be more pliable allowing it to form into shape during installation.
WARNING
- VERY IMPORTANT! SITE MUST BE LEVEL, STABLE, COMPACTED SOIL.
• The pool must be assembled on a smooth and level site of firm soil that is free of stones, gravel, sticks, blacktop, or other oil-based compounds.
• Before setting up your pool, it is recommended that you clear the area of hardy grasses. Certain types of vigorous grasses such as St. Augustine and
Bermuda can grow through the liner. A ground sheet or tarp may be helpful in preventing this from occurring. Grass growing through the liner is not covered
under warranty.
• Do not install the pool on a wooden deck or any type of wooden surface. You cannot use sand and/or uncompacted soil to provide a level surface for this pool;
it will only wash out.
• FAILURE TO FOLLOW ALL OF THESE INSTRUCTIONS WILL CAUSE THE POOL TO COLLAPSE AND WILL VOID THE WARRANTY!
Site Preparation
1. Select a level area, and completely remove all debris, twigs, stones, etc. DO NOT select an area under overhead electrical lines, trees, or within 15' (4.6 m) of a
house, building, etc.
2. The pool shall be located a minimum distance of 6' (1.83 m) from any electrical receptacle.
3. Contact your local utilities, to check that no underground cables, telephone lines, gas lines, etc. run beneath the area you have selected.

Assembly Instructions

1. Locate a level and flat area to set up the pool. Make sure the ground is free from sharp objects, as they may puncture the pool.
2. Carefully unfold the pool liner in the area selected and inspect the seams for manufacturing defects.
3. It is recommended to let the pool sit out in direct sunlight for about 2 hours prior to installation. (see TIP above)
4. LIFT the pool liner across the ground. DO NOT drag the liner from one location to another location.
5. Locate the pool so that the pump opening is 10 to 21' (3 to 6.4 m) from the electrical outlet.
2 3
Horizontal Beam Vertical Leg
Part # Qty. Part # Qty.
P5A1B0002E02 16 P5A2B0004E02 16
4 5
EZ-Link
T-Fitting
T-Fitting
Part # Qty. Part # Qty.
P5A3B0015E02 15 P5A3B2015E02 1
ASSEMBLY INSTRUCTIONS

PARTS LIST

6 7
Pin and Grommet
Leg Cap
(with 2 extra)
Part # Qty. Part # Qty.
P5APF5910G8U 16 P5A593144G8U 34
8
Pre-installed
V-Shaped Spring Pin
(with 1 extra)
Part # Qty.
P5APF5920G8U 17
7