Pool Maintenance And Draining - Outbound 081-3852-0 Operating Instructions Manual

ASSEMBLY INSTRUCTIONS
RX CARTRIDGE FILTER PUMP
Outside Pool Wall
Inside Pool Wall
Water Cap Suction Fitting Fitting Gasket Suction Fitting
Washer
SUCTION FITTING
NOTE: For Sand Filter Pump/Cartridge Filter Pump CP2000-C, please follow the Sand Filter Pump/Cartridge Filter Pump CP2000-C
owner's manual to set up the fitting. Please check the water pump's instruction manual for more instructions.
Please Note: The black rubber gasket (Fitting Gasket) should always be placed over the threaded plastic suction or return fitting and be on the inside before the
fitting is placed through the pool wall to make a watertight connection.
Make sure to put on both the Water Cap and the Service Plug while you fill your pool, or until you are ready to add a filtration system.
POOL MAINTENANCE AND DRAINAGE
CAUTION
: ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
Do not add chemicals if the pool is occupied. This can cause skin or eye irritation. Concentrated chlorine solutions can damage the pool liner. In no event is
Trileaf Distribution, the buyer/retailers, or any other party liable for costs associated with the loss of pool water, chemicals, or water damage. Keep spare filter
cartridges on hand. Replace cartridges every two weeks. We recommend the use of Outbound
a Outbound Filter Pump or other accessories, visit the retailer where pool was purchased or visit our website.
TM
EXCESSIVE RAIN: To avoid damage to the pool and overfilling, immediately drain rainwater that causes the water level to be higher than the FILL LINE.
How to Drain Your Pool and Long Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Make sure the drain plug inside the pool is plugged in place.
3. Twist off the cap of the drain valve on the outside of the pool.
4. Attach a 5/8" garden hose to the drain valve.
5. Place the other end of the garden hose in an area where the water can be safely drained away from the house and other nearby structures.
6. Unplug the inner cap of the drain plug to start draining the pool.
7. When the water stops draining, start lifting the pool from the side opposite to the drain valve to drain any remaining water and empty the pool completely.
8. Replace the drain cap on outside of pool.
9. Be sure that the pool and all parts are completely dry before storing. Air dry the liner in the sun until completely dry before folding (see drawing 1).
Sprinkle some talcum powder to prevent the vinyl from sticking together and to absorb any residual moisture.
10. Create a square shape. Starting at one side, fold one-sixth of liner into itself twice. Do the same on the opposite side (see drawings 2 & 3).
11. Once you have created two opposing folded sides, simply fold one over the other like closing a book (see drawings 4 & 5).
12. Fold the two long ends to the middle (see drawing 6).
13. Fold one over the other like closing a book, and finally compact the liner (see drawing 7).
14. Store the liner and accessories in a dry, temperature-controlled storage location above 32°F (0°C) and below 104°F (40°C).
15. The original packing can be used for storage.
10
Outside Pool Wall
Inside Pool Wall
Fitting Lock
Return Fitting
Return Fitting Fitting Gasket
Nut
Diverter
RETURN FITTING
Inside Pool Wall
Fitting Lock
Nut
SUCTION FITTING
Filter Pump with all of our above-ground pools. To purchase
TM
SFX SKIMMERPLUS FILTER PUMP
Inside Pool Wall
Return Fitting
Diverter
Service Plug
Locking Ring Return Fitting
RETURN FITTING
TM
Outside Pool Wall
Fitting Gasket RF Nut
Suction Fitting
Washer
90° Elbow