Cleaning And Care - Powerfix Profi 114470 Operation And Safety Notes

2. Adjust the impact force to suit the materials,
staples or nails.
3. Press the operating lever
Examples of use:
The stapler gun is suitable for the following purposes:
- Attaching coverings to the seating surface of
chairs.
- Attaching a skirting at the joint between wall
and floor coverings.
- Stretching and stapling canvasses to frames.
- Attaching protective films to insulation materials
when installing thermal insulation.
- Attaching decorative materials.
Removing staples
Q
To avoid the risk of injury!
Ensure that the operating handle
pressed.
Push the hook
4
(see Fig. F).
Pull the rear part of the stapler gun upwards to
draw out the staple or nail from the workpiece.
Removing jammed staples
Q
from the stapler gun
Staples or nails may become jammed in the stapler
gun during operation. Remove jammed staples as
follows:
1. Press in the staple pusher
pull it downwards. Then pull the staple pusher
completely out of the magazine
2. Turn the stapler gun over so that the magazine
5 is pointing upwards.
3. Press the magazine
backwards and pull the magazine
(see Fig. E).
4. Now remove the jammed staples from the
magazine 5 .
5. Press the magazine
backwards and press it downwards until it en-
gages to fix the magazine
114470_pow_Handtacker_Content_GB_FI_NL.indd 7
down firmly.
2
2 will not be
under the staple or nail head
slightly and then
3
3
.
5
5 at the side wings 6
upwards
5
5 at the side wings 6
back in place.
5
Operation / Cleaning and care / Service
Note: Do not use the stapler gun if it shows more
serious defects (damage to body etc.). If necessary
have your stapler repaired by a qualified specialist.
Take note that the manufacturer's original spare
parts only should be used in any repair.
Tips
Q
1. In order to have a good quality of stapling, it is
suggested to fill only one of staple / nail type in
the staple gun in each time.
2. When you want to change other types of sta-
ples, please make sure all remaining staples /
nails are used up or not in staple gun before
insert other types of staples/nails.

Cleaning and care

Never use corrosive or abrasive cleaning
agents. These may damage the surface of the
product.
The product must be kept clean, dry and free
of oil or lubricants at all times.
Clean the product with a slightly dampened,
non-fluffing cloth.
Service
Securely pack the product or use the original
packaging to prevent transport damage.
Abraham-Diederichs products are submitted to
strict quality control. If a malfunction occurs, howev-
er, please send the product to our service address.
A brief description of the defect will speed up trou-
bleshooting and repairs. Please include the sales
receipt with the product during the warranty peri-
od. If the repair is not covered by warranty, we will
invoice you for the repair.
Important! We expressly state that according to
the Product Liability Act, we are not liable for dam-
ages caused by our products, if these were caused
by improper repair, or if parts were replaced not
using our original parts or parts approved by us.
GB/IE 7
28.07.15 08:20